Boynton Rectangular 96-120 Inch Extension Dining Table in Cliffside Oak and Bronze

Needed a sandblaster and struggled with what to buy. Lots of good and bad reviews on ALL of them. Bought the Lematec kit and I must say it worked very well for me. I have a 15 gal DeWalt compressor 5-10 CFM. It struggled to keep up with the big pieces (headers) but had no trouble with brackets and such. I used 70 grit aluminum oxide from Harbor Freight. For two days, it worked perfectly. On the third day, I started early and there was a ton of moisture in the air lines from the cold overnight. I didn't empty the valve soon enough and I began to blow water vaper on the header. The amount of moisture in the line was rather surprising. Very little the first two days, tons on the third day. The gun clogged twice and I had to take it apart to clean. 10 minutes tops. I quickly learned to keep the moisture cleared and the gun worked fine. I used the gravity feed initially but got tired of feeding it. It gave my compressor a chance to catch up but switched to the suction feed and never went back. The gun worked best above 90 PSI. It did not work well below 90 and not at all below 80. The pressure indicator valve helped to me to do a quick check when it wasn't working as well. Keep it fed with media, pressure above 90, moisture level down and it will work like a champ. Side note, use a full face sheild. It will help. I used safety glasses but found the media could still get in. I used both and eliminated the problem. Also, use an N95 respirator. Don't be cheap or lazy. You can buy then relatively cheap on Amazon. It works great as a table piece in our home.